Browse all practice questions for the Hazardous Materials Awareness Army 74D Practice Test. Search by topic, open any question and review its full explanation, then test yourself in the practice quiz.

Hazardous Materials Awareness Army 74D Practice Test course image
More practice questions

These questions are part of the practice quiz. Start practicing

  • Which of the following are among the common symptoms of inhalation HazMat exposure?
  • Which statement correctly describes 5.2 Type B materials?
  • What is the purpose of cross-contamination control in PPE use?
  • Acetone has a flash point no more than 140°F. How is it classified?
  • BLEVE stands for what?
  • Which action focuses on stopping spills from migrating by controlling flow at the source?
  • Class 5 materials are primarily associated with which hazards?
  • How should you respond to a suspicious package on an installation?
  • Hazardous waste is regulated under RCRA by which federal agency?
  • What is the purpose of absorbent material during a HazMat spill?
  • Wetted explosives: Wetting explosives with alcohol or water does what?
  • Phosphorus is an example of which hazard category?
  • Which division describes extremely insensitive articles with no mass explosion hazard (squib)?
  • Why is it important to maintain situational awareness during HazMat incidents?
  • Which of the following is NOT a route of entry for hazardous substances?
  • Which division describes mass explosion hazard extremely insensitive (prilled ammonium nitrate with fuel)?
  • Which of the following is NOT part of typical HazMat exposure reporting in the Army policy?
  • A good demonstration of HazMat reporting to the chain of command is to:
  • Which agency would regulate Highly Hazardous Chemicals for worker safety?
  • Which statement best explains why HazMat materials should be segregated during storage?
  • WMD stands for which concept in hazardous materials context?
  • In the ERG, ID numbers are found in which pages?
  • Which term is regulated by UN model codes and regulations?
  • How can you minimize environmental impact during a HazMat spill?
  • What action should you take immediately if HazMat spills on your clothing?
  • Which measure primarily establishes a physical boundary to prevent HazMat spills from reaching water sources?
  • Where is the container profile information located in the ERG?
  • Why is segregation important when storing HazMat?
  • Where would you find placard information in the ERG?
  • What is the primary form of air shipping papers?
  • In NFPA 704, what does the blue (left) section represent?
  • Solid containers for hazardous materials are commonly which types?
  • Pipelines transport which materials?
  • Which practice uses absorbent materials to manage a spill and reduce water contamination?
  • What is the purpose of establishing hot, warm, and cold zones in a HazMat incident?
  • Which statement best defines a pyrophoric material?
  • What is the difference between corrosive and non-corrosive HazMat?
  • Which statement about the Global Harmonized System (GHS) is true?
  • Which practice does NOT contribute to cross-contamination control?
  • Which statement correctly describes 5.2 Type C materials?
  • Which statement best describes a 5.2 type F material?
  • What is the primary purpose of Hazardous Materials Awareness training for Army personnel?
  • What information does the Safety Data Sheet (SDS) primarily provide?
  • Which action does NOT contribute to cross-contamination control in PPE use?
  • Which action is part of the zone control concept?
  • Cryogenic containers are designed to transport which type of cargo?
  • Pipeline markers are metal signs placed adjacent to and above a hazmat pipeline to indicate the pipeline's ________?
  • In the NEPA 704 rating system, what does the letter W indicate on the label?
  • Define hot zone, warm zone, and cold zone in a HazMat incident.
  • Which set of elements is typically found on a HazMat shipping paper?
  • Readily combustible solids are described as:
  • What should be done if you cannot identify a HazMat substance from labels and markings?
  • Which color in NFPA 704 represents the flammability hazard?
  • ORM-D describes what kind of hazard?
  • Class 6 hazards include which of the following?
  • How is the notification process defined?
  • Which option is NOT a recommended way to prevent HazMat spills from entering water sources?
  • Which items are described as 3.9 inches square-on-point diamonds?
  • Highly hazardous chemicals are defined by possessing which properties?
  • Which is an example of Class 7 material?
  • Which agency must be notified for extremely hazardous substances?
  • ORM-D refers to which concept?
  • Division 4.3 hazard covers which type of materials?
  • What information is typically included in the markings on the outer packaging of hazardous materials?
  • Which statement best describes military markings as they pertain to hazardous materials?
  • Which of the following is a visual indicator of a potential chemical release event?
  • Which statement correctly describes 5.2 Type B materials?
  • Which statement best identifies the division of fireworks hazard?
  • Shipping papers follow a specific sequence. Which option correctly describes the ISHP sequence?
  • Which item is NOT typically found on a HazMat shipping paper?
  • Which DOT hazard class corresponds to flammable liquids?
  • Dangerous goods are regulated by which set of codes and regulations?
  • Which technique is used to isolate a hazard on the scene?
  • Communication methods are covered in which procedures and what training is required?
  • Which item is NOT listed as a visual indicator of chemical actions?
  • What is the primary purpose of the Emergency Response Guidebook?
  • Which pages contain identification numbers in the ERG?
  • Name a common health hazard route of exposure to HazMat.
  • Which statement about HazMat exposure reporting is NOT correct?
  • Which division covers gases poisonous by inhalation?
  • Which of the following is NOT a recommended HazMat reporting action to the chain of command?
  • Chronic health effects are defined as which of the following?
  • Which statement about the NEPA 704 system is correct?
  • Which term from the list is regulated by UN model codes and regulations?
  • In Class 2, the major hazard is BLEVE. Which term corresponds to BLEVE?
  • BLEVE hazard relates to which phenomenon?
  • What is the first action you should take to contain a HazMat spill?
  • Class 1 shipments are associated with which hazard?
  • What is the role of the Emergency Response Guidebook (ERG) in an initial HazMat incident assessment?
  • Where is a Safety Data Sheet (SDS) typically located?
  • Which term describes health effects that are long-term or recurring?
  • Class 7 designates which type of hazard?
  • Which of the following is NOT an energy release type that can present a threat?
  • Which statement correctly describes Division 4.1 contents?
  • Which statement accurately describes corrosive HazMat risk?
  • Which description corresponds to 5.2 Type D materials?
  • Division 1.5 refers to which hazard description?
  • Which statement accurately differentiates Division 5.1 and 5.2?
  • Hazardous substance is regulated by which agency?
  • Which statement about UN/NA numbers is true?
  • What are the three categories rated in the NEPA 704 system?
  • What is the ERG primarily used for in hazardous materials incidents?
  • What is the difference between a hazard label and a placard in HazMat terminology?
  • Class 9 designates which type of hazard?
  • Which shipping papers are used for highway transport?
  • Placards are used to identify hazard class. Which term completes the sentence: Each hazard class has a specific __________ that identifies the material's class?
  • Delayed effects are best described as which of the following?
  • How should unknown chemical odors be treated in the field?
  • Where on the ERG would you find information about the materials transportation placard?
  • Which color on the NFPA 704 diamond indicates the health hazard?
  • Chlorine is an example of which hazard type?
  • Which types of containers are commonly used for HazMat packaging in Army operations?
  • Which division describes nonflammable, nonpoisonous gas at cryogenic conditions with 40.6 psi or greater at 68 degrees (argon)?
  • After exposure to HazMat, how long should you flush the skin with water?
  • What should you do with decon effluent after HazMat decontamination?
  • Which hazard class is associated with acetone, gasoline, and similar solvents?
  • Container profile is referenced in which pages?
  • Acute health effects are defined as which of the following?
  • What is the difference between a hazard label and a placard?
  • What does 'packaging group' indicate in HazMat classification?
  • Division 1.6 refers to which hazard?
  • Name the four NFPA 704 hazard codes and what the colors roughly indicate.
  • Corrosive materials belong to which class?
  • Which statement best defines a self-heating material?
  • Which shipping papers are used for rail transport?
  • What is the purpose of the Safety Data Sheet (SDS) and when is it used in HazMat awareness?
  • Gross decontamination is defined as which of the following?
  • Which sequence correctly describes the steps to take if HazMat spills on clothing?
  • Radioactive materials containers are packaged according to which categories?
  • Which of the following is a sensory indicator of chemical reactions?
  • Why should you not smell, taste, or touch HazMat substances?
  • Which resource helps quickly identify hazards at a transportation site?
  • Which PPE level provides the highest protection during HazMat incidents?
  • What does the packaging group indicate on HazMat shipping papers?
  • Which statement about 5.2 categories E, F, and G is true?
  • Which indicators may appear in the white section of the NFPA 704 diamond?
  • What action should you take if you witness a HazMat incident aboard a vehicle you are driving?
  • Which statement describes protective actions during hazmat incidents?
  • Which of the following is the primary role of a placard?
  • What information can be obtained from a HazMat shipping paper during an incident?
  • Which item is NOT a component of Division 4.1 flammable solids?
  • What is the typical sequence for scene actions: isolate, notify, decon, and dispose?
  • Which hazard is most associated with liquid containers?
  • Division 6.1 includes which type of hazardous materials?
  • Which division indicates projection hazard (aerial flares)?
  • Division 2.1 refers to which type of material?
  • Diesel is classified as which type of liquid?
  • Division 5.1 refers to which type of material?
  • The agency historically used to cover 9 classes of hazardous materials is which?
  • Which document should responders consult to identify immediate actions, PPE recommendations, and evacuation distances?
  • Division 6.2 encompasses which substances?
  • Which division describes minor explosion hazard with no blast or projection hazard (fireworks)?
  • Compared with many other container types, liquid containers typically have which end geometry?
  • To reference the chemical name in the ERG, you would consult which pages?
  • Extremely hazardous substances must be reported to which agency?
  • When reading a label, what does a four-digit UN number provide?
  • What is the purpose of the white section in the NFPA 704 diamond?
  • If exposure persists after decontamination, what should you do?
  • What is a UN number and why is it important for HazMat responders?
  • What is the role of the Incident Command System (ICS) for awareness personnel during a HazMat incident?
  • What does the white section in the NFPA 704 diamond indicate?
  • Acute health effects are described as which of the following?
  • Class 5 hazards are primarily associated with which substances and outcomes?
  • What information does the NFPA 704 diamond convey at a glance?
  • What should you do if your PPE becomes damaged or compromised during a HazMat incident?
  • Which division corresponds to flammable gas at 68 degrees (propane)?
  • Which statement about the Global Harmonized System is true?
  • Solid containers for hazardous materials are typically what?
  • Which statement best describes hazmat markings?
  • Which statement best describes a HazMat shipping paper?
  • Why is it important to wear appropriate PPE when handling a HazMat spill?
  • Which pages are used to reference the name of materials in the ERG?
  • Which division describes fire hazard with minor blast or projection hazard (propellant explosives)?
  • What are water shipping papers used for?
  • NFPA 1072 is the standard associated with which topic?
  • Which is a sensory indicator of chemical reactions?
  • Which of the following is an ignition source?
  • Self-reactive materials are:
  • How should you handle a small spill of a non-volatile liquid on a clean surface?
  • Hazardous chemicals pose risk to employees; which agency regulates safety guidance and worker protection?
  • Which statement correctly describes 5.2 Type A materials?
  • A liquid with a flash point no more than 140°F is classified as what?
  • Infectious Substances are categorized under which Class and Division?
  • Which of the following describes the typical HazMat exposure routes?
  • Which statement best describes a 5.2 type E material?
  • Which statement correctly describes 5.2 Type A materials?
  • What should you do to isolate a HazMat spill before responders arrive?
  • Which statement about Safety Data Sheets (SDS) is correct?
  • Division 5.2 refers to which type of material?
  • Division 4.3 hazard is best described as covering which of the following?
  • Which is a mechanism of harm for hazardous materials?
  • Which packaging types are used for radioactive materials?
  • Division 2.3 hazards are characterized as:
  • Division 4.2 covers which type of materials?
  • Which route of entry describes absorption through the skin?
  • Why should responders maintain situational awareness and avoid unnecessary exposure?
  • Name three immediate actions you should take when approaching a suspected HazMat incident.
  • Which classification covers flammable liquids?
  • Which division indicates mass explosion hazard (TNT)?
  • Hazardous material is defined by which standard?
  • What does BLEVE stand for?
  • Which of the following is an ignition source that involves friction?
  • Which of the following is listed as an energy release form that can present a threat in hazmat incidents?
  • Which action would best maintain PPE effectiveness by preventing contamination?
  • Which statement best describes a 5.2 type G material?
  • What is typically required regarding reporting HazMat exposures in the Army?
Subscribe

Get the latest from Passetra

You can unsubscribe at any time. Read our privacy policy